ICClone
a memory transfer utility for ICOM radios
Download ICloneSetup.exe version 1.3 by clicking here. If the file tries to execute rather than download, right click the link and choose "Save as". After the download, double click it to install.
Everything seems to work OK, but I don't guarantee it. Please try it in the READ mode first, save that file if it looks OK, so that if the WRITE fails you have a record of what your memories used to contain.
Instructions for use are below. Please read them all.
Click here to see a list of supported radios, and functions.
Email me if you have problems or suggestions.
The following were
instrumental in developing ICClone. Thank you.
Ron, N4GFO - Ekki, DF4OR - Richard, K4UTE - Mike, KD9KC - Len VE3FJB/VA3LM -
Mel, VE2DC
:
How to use
-
If this is your first time, set the serial parameters, and your radio's address, then click the Initialize.Led. Once all the parms are set, the read and write icons will be enabled.
-
Click the Read icon to read your memories into the grid. ICClone will cycle through all the memories, so don't terminate it early.
-
To load the memories from the file/grid into the radio, click the Write icon.
-
You can type over entries in the grid, and re-order them by drag-n-drop. Click on a row to select it (it will turn black), then click (and hold down) the left mouse button on the little square at the left end of the row. The cursor will change to a flag. Drag the row to the position you want, and release the mouse button.
-
Clicking the Renumber icon will consecutively re-number all the memory channel numbers. If you had gaps, they will be gone.
-
You can save the list to a file. This also saves the serial and radio setings settings.
-
To load a previously saved file, Click File/Open and select the appropriate .ini file. There's a demo ini file with "typical" settings. Loading an .ini file automagically initializes the serial port and the radio.
-
There are two save options, "Save" and "Save as". Save will replace the current file with the screen contents, and Save as creates a new file with a different file name.
-
To enable logging the commands sent and received for diagnostic purposes, click File menu and select Log for debug.
visitors